3D printed M3 nut mounting tool with embedded magnet
Often these little nuts tend to drop in your device while trying to mount them. With this tool you can hold it in place without fearing it will drop.
This is a tool for mounting M3 nuts in a difficult to reach place, mainly in electronic devices. It has a 3mm magnet embedded, so I included the gcode-file with a pause at layer 14 (beep: insert magnet and hit button to continue). It is NOT a wrench: only to hold the nut for mounting.
The g-code file shows you the parameters: PLA at 205°C / bed 60°C / pause temp: 200°C / keep motors engaged (to prevent displacement during pause).
The g-code file shows you the parameters: PLA at 205°C / bed 60°C / pause temp: 200°C / keep motors engaged (to prevent displacement during pause).
Diskussion (0 Kommentare)